电子邮箱

密码

安全问题

注册 忘记密码?

无锡微色谱生物科技有限公司

见微知著,样品分析,如虎添翼

JA0052 Solid Phase Extraction Technique – Trends, Opportunities and Applications
来源:POLISH JOURNAL OF ENVIRONMENTAL STUDIES | 作者:A. Żwir-Ferenc | 发布时间: 2124天前 | 3604 次浏览 | 分享到:
Solid phase extraction (SPE) is an extraction method that uses a solid phase and a liquid phase to isolate one, or one type, of analyte from a solution. it is usually used to clean up a sample before using a chromatographic or other analytical method to quantify the amount of analyte(s) in the sample. The general procedure is to load a solution onto the SPE phase, wash away undesired components, and then wash off the desired analytes with another solvent into a collection tube. Solid-phase extractions use the same type of stationary phases as are used in liquid chromatography columns. The stationary phase is contained in a glass or plastic column above a frit or glass wool. The column might have a frit on top of the stationary phase and might also have a stopcock to control the flow of solvent through the column. Commercial SPE cartridges have 1-10 ml capacities and are discarded after use. it is usually used to clean up a sample before using a chromatographic or other analytical method to quantify the amount of analyte(s) in the sample. Solid phase extraction procedures are used not only to extract traces of organic compounds from environmental samples but also to remove the interfering components of the complex matrices in order to obtain a cleaner extract containing the analytes of interest. The SPE technique is widely applied for isolation of analytes from a liquid matrix and purified extracts. This paper is a review of the literature regarding general information about SPE technique, new trends in SPE technique and its application.
1 Introduction

Solid phase extraction is the very popular technique currently available for rapid and selective sample preparation. The versatility of SPE allows use of this technique for many purposes, such as purification, trace enrichment, desalting, derivatisation and class fractionation. The last few years have been chracterized by a wide interest in this technique and many publications describing SPE methods have been published [1]. This period is connected with the intensive development of research procedures for novel types of sorptive materials and lasted from the late 1960s until the beginning of the 1980s. The introduction of a wide spectrum of sorptive materials into analytical procedures gave a new stimulus for the development of SPE methodology [2].


.....


阅读全文
  • 三种 Protein A树脂纯化效率比较及流程优化

    2021-09-20

    简要介绍 dSPE 在全自动移液工作站上应用实现全自动抗体纯化的原理。
    比较了三种 Protein A 纯化 HIgG 的效率及纯化流程优化方法。

  • 使用 IMCSTips 实验全自动纯化(一步)方法及数据分析

    2021-09-20

    1. IMCStips 应用原理展示
    2. His-tagged 蛋白纯化流程优化及数据分析

  • 全自动抗体、蛋白纯化演示

    2021-09-20

    IMCStips 亲和层析柱
    ● 一次层析即可快速产生高纯重组蛋白
    ● 一致性好、回收率高,个样品的差异不到 10%
    ● 可结合各种复杂方法的模板化工作流
    ● 与 Hamilton 移液工作站结合,可在 30 分钟内处理 96 个样品
    ● 可定制的工作流程

  • 振荡器-BenchWaver

    2020-02-08

    BenchWaver™ 把传统的平台摇摆运动与轨道振动器的圆周运动结合起来,这种最优组合能够产生最适合分子生物学应用的三维运动。

  • 均质机-D1030 演示

    2020-02-08

    强力混匀,适于细胞裂解、研磨或均质
    与通用的组织研磨机更快速、更高效
    采用密封2.0mL管,消除交叉感染
    中通量,可同时处理3~6个样品